Filter
Top Products
Utility Mode [UTILITY]
Reference
DTXTREME III Owner’s Manual
127
Drum Kit mode
Reference
Song modeClick modeTr igger modeFile modeUtility modeChain modeSampling mode
Effect Settings [F3] EFFECT
Among the entire Effect system (page 68) of the DTXTREME III, the parameters related to the Master EQ and Master Effect
can be set in the Utility mode.
From this display you can apply five-band equalization to
the entire sound of the DTXTREME III.
1 SHAPE
Determines whether the equalizer type used is Shelving or
Peaking. The Peaking type attenuates/boosts the signal at the
specified Frequency setting, whereas the Shelving type atten-
uates/boosts the signal at frequencies above or below the
specified Frequency setting. This parameter is available only
for the LOW and HIGH frequency bands.
● shelv (Shelving type)
This type of EQ shape lets you attenuate/boost the signal at
frequencies above or below the specified Frequency setting.
● peak (Peaking type)
This type of EQ shape lets you attenuate/boost the signal at
the specified Frequency setting.
B FREQ (Frequency)
Determines the center frequency. Frequencies around this
point are attenuated/boosted by the Gain setting.
LOW When the Shape is set to “shelv”:
32Hz – 2.0kHz
When the Shape is set to “peak”:
63Hz – 2.0kHz
LOWMID, MID, HIGHMID
100Hz – 10kHz
HIGH 500Hz – 16kHz
C GAIN
Determines the level gain for the Frequency (set above), or
the amount the selected frequency band is attenuated or
boosted.
D Q (frequency bandwidth)
This varies the signal level at the Frequency setting to create
various frequency curve characteristics. The higher the set-
ting, the smaller the Q (Bandwidth). The lower the setting, the
greater the Q (Bandwidth).
E [SF5] BYPASS
Pressing this button toggles the bypass status of the Master
EQ between on and off. When Bypass is turned off (BYPASS
is shown with white text in black), the Master EQ will be
applied to the entire sound of the DTXTREME III. When
Bypass is turned on (BYPASS is shown with black text in
white), the Master EQ will be bypassed for the entire sound of
the DTXTREME III.
NOTE
•For details about the Effect structure of the DTXTREME III, see page 68.
Master EQ Settings
[SF1] MEQ
Settings shelv (Shelving type), peak (Peaking type)
Low HighHi-MidMidLo-Mid
–
+
0
Q (frequency bandwidth)
5 bands
Gain
Frequency
2
3
1
4
5
–
+
0
–
+
0
EQ Low EQ High
Gain
Frequency
Gain
Frequency
Frequency Frequency
Range See below.
Range -12 dB – +0 dB – +12 dB
Range 0.1 – 12.0
–
+
0
Gain
Frequency
Frequency
–
+
0
0.1
12.0
Frequency
Frequency