Filter
Top Products
Reference
124
DTXTREME III Owner’s Manual
Reference
Drum Kit mode Song mode Click mode Trigger mode File mode Utility mode Chain mode Sampling mode
Utility Mode [UTILITY]
This chapter explains the Utility mode called up via the [UTILITY] button.
In the Utility mode, you can set parameters that apply to the entire system of the DTXTREME III.
Basic Procedure in the Utility Mode
1
Press the [UTILITY] button to enter the
Utility mode.
2
Note the tab menus (corresponding to the
[F1] – [F6] and [SF1] – [SF5] buttons) to
find the desired function, then press the
relevant button to call up the desired dis-
play.
3
Move the cursor to each parameter, then
set the value by using the data dial, or the
[INC/YES] and [DEC/NO] buttons.
4
After setting, press the [ENTER/STORE]
button to store the Utility settings.
General Settings [F1] GENERAL
From this display, you can make overall settings for the
internal tone generator. The settings here only affect the
internal tone generator block. The MIDI output will not be
affected.
1 Volume
Determines the overall volume for the tone generator. The
lower the value, the lower the actual volume will be when set-
ting the slider on the front panel to maximum.
B Pan Depth
Determines the pan depth (the left and right stereo spread),
maintaining the current pan balance between various parts.
C Tune
Determines the fine tuning of the overall sound. You can
adjust the tuning in cent increments.
From this display, you can set the output gain for individual
Output jacks. The higher the value, the louder the actual
volume of the sound output via the specified Output jack.
1
L&RGain
Determines the output gain of the OUTPUT L/MONO, R and
PHONES jacks.
B IndivOutGain
Determines the output gain of the INDIVIDUAL OUTPUT
jacks. The setting here is applied to all the INDIVIDUAL
OUTPUT jacks.
• All Utility settings will be lost if the power is turned off without stor-
ing.
CAUTION
Tone Generator Settings
[SF1] TG
Settings 0 – 127
Settings 1 – 127
Settings -102.4 – 0 – +102.3
1
2 3
Output Gain Settings of the Output
Jacks
[SF2] OUTGAIN
Settings 0dB, +6dB
Settings 0dB, +6dB
1
2