Open as PDF
● Loop Point
This display determines how your sampled waves play back.
Your sampled waves can be played back in three different ways as follows:
ABC D E
ABC D E BC D
Press this to actually edit
the selected wave.
The LEVEL indicators the right of each address
show the signal level at the current address —
the longer the bar, the higher the signal level.
This makes it easier to locate zero-level points
for noise-free trimming and looping.
When the ONE SHOT or REVERSE is
selected, select either the Start or End
address of the wave.
When the LOOP is selected, select the Start,
Loop Start or Loop End address of the wave.
When this is turned ON, the LOOP ADDRESS
LCD buttons will automatically only select
points in the wave corresponding to, or adja-
cent to, zero level points.
Press this to automatically
remove all data prior to the
speciﬁed Start point and
after the End or Loop End
point of your sample.
See the illustration below.
Start point Loop Start
B, C, D, C, D, C, D ....