Filter
Top Products
Chapter 10: Using Effects
212 ANDROMEDA A6 REFERENCE MANUAL
STEREO
The Stereo Room, Quad Pitch Shifter and Quad Chorus configurations are special
single algorithms that treat the incoming left and right signals differently, but still
create a synthesized stereo image from each side, depending on the setting of the
Width control. If the width is set to 99%, a signal appearing at the left input (as set
by the PAN control inside the effect display—NOT the control on the Voice Mix
output section) will be processed and sent to only the left output; if the width is set to
00%, the processed signal will appear in stereo at both outputs.
Stereo
Chorus/Flanger
has two separate mono signal paths that are controlled by
synchronized parameters to give a total stereo effect.
Stereo Chorus/Flanger is not always a Stereo Effect, because each side of the chorus
feeds only one side of the output. Depending on its input
PAN setting, it can assign
the chorus to either or both channels. Unlike the Dual Mono configurations,
however, it doesn't have independent control of the parameters for each side, or left
and right output level controls.
Effects that use this configuration:
Stereo Room
Quad Chorus
Quad Pitch Shifter
Stereo Chorus/Flanger
PAN