Filter
Top Products
Chapter 12: MIDI Functions
ANDROMEDA A6 REFERENCE MANUAL 257
CC MAP Page Parameters
The fourth page of the GLOBAL menu allows you to set which of the 120 MIDI
Continuous Controller messages will be transmitted by the Andromeda's controllers.
PAGE PARAMETER
OPTIONS
or RANGE DESCRIPTION
CC MAP
PED CC
Pedal
OFF
1 ··· 120
This parameter determines what MIDI
Continuous Controller number will be
transmitted by a pedal plugged into the
CV/PEDAL jack on the rear panel. Note that if
you assign the CC Pedal to CC 7 (corresponding
to MIDI Volume), the pedal will automatically
control the A6’s Master Volume without the
need to set up a dedicated Mod Route.
FSW CC
Footswitch
OFF
1 ··· 120
SSHOLD
SSTOGL
Sets MIDI Continuous Controller number that
will be transmitted by a pedal plugged into the
SWITCH jack on the rear panel. When set to
SSHOLD, pressing down on the Footswitch will
send out a MIDI Start Message, and releasing it
will send a MIDI Stop Message. When set to
SSTOGL, pressing the Footswitch once will send
a MIDI Start Message and pressing it again will
send a MIDI Stop Message. With these settings,
you can use the Footswitch to control an external
sequencer.
RIBVCC
Ribbon Value
OFF
C20C52
C31C63
Sets MIDI Continuous Controller number that
will be transmitted by the entire Ribbon. Note
that this is a two-byte quantity requiring two
Continuous Controller numbers.
RIBLCC
Ribbon Left
OFF
1 ··· 120
Sets MIDI Continuous Controller number that
will be transmitted by the left part of the Ribbon
when it is split in the middle.
RIBRCC
Ribbon Right
OFF
1 ··· 120
Sets MIDI Continuous Controller number that
will be transmitted by the right part of the
Ribbon when it is split in the middle.
CTL NUM
Continuous
Controller
Number
CC A-H
Selects which letter (A through H) of the A6's
Modulation sources will be mapped to a
particular incoming Continuous Controller
number. CC A etc. appear as Sources in MOD
menus all over the Andromeda, allowing MIDI
control of individual synth settings in real time.
CC IN
Continuous
Controller Input
0··· 127
Sets what CCnumber will be used to control the
Mod source currently selected by
CTL NUM
above.