Filter
Top Products
Chapter 2: Playing the A6
ANDROMEDA A6 REFERENCE MANUAL 67
PAGE PARAMETER
OPTIONS
or RANGE
DESCRIPTION
PWHEEL
Continued
TOPCRV
Top Curve
LINEAR ···
SCURV2
This parameter selects one of nine response
curves for the wheel’s upper travel. See the
discussion on curves starting on page 62.
OSC 1
OFF
, ON
Turn the effect of the Pitch Wheel on OSC 1 on or
off.
OSC 2
OFF
, ON
Turn the effect of the Pitch Wheel on OSC 2 on or
off.
MOD ASSIGN Parameters
SOFT KNOB
PAGE TAB
1 2 3 4 5 6 7 8
MODWHL SCALE CURVE
CROUTE SOURCE LEVEL ENABLE ROUTE
PAGE PARAMETER
OPTIONS
or RANGE
DESCRIPTION
MODWHL
SCALE 0 ··· 100
Adjusts the modulation amount from the wheel.
Higher values = more modulation.
CURVE LINEAR ···
SCURV2
This parameter selects one of nine response
curves for the wheel’s travel. See the discussion
on curves starting on page 62.
CROUTES (Control Routes)
A second press of either the PITCH ASSIGN or the MOD ASSIGN button will bring up the
CROUTES page. This allows you to see and change the internal routings of the
controllers. By turning the
ROUTE knob, you can see the source routed to that
destination. You’ll need to enter this page whenever you want to create custom
control setups that are different from the defaults. For more information, see
Chapter 9: Custom Modulations.
Ribbon HOLD Buttons
On each side of the ribbon there are HOLD buttons. When ribbon hold mode is on, the
ribbon value will be “sticky”. That is, when you lift your finger from the ribbon, it
will hold its value. When you exit ribbon hold mode, the ribbon value will snap back
to zero.