Filter
Top Products
Chapter 2: Playing the A6
ANDROMEDA A6 REFERENCE MANUAL 73
START/STOP Button
Pressing this button enables or
disables the Sequencer. This is a
programmable parameter that is
saved with each Program and
with each Mix Channel
separately. So, you can have the
sequencer enabled for a program
in Mix Mode and disabled for
that program in Program Mode.
Remember, the sequence will
not start until it receives a
trigger, normally the keyboard.
SYNC/MOD Button
Pressing this button displays the
Sequencer’s
MOD page on the
screen. The Sync/Mod page of
parameters allows you to
modulate the tempo of the sequence. The Sync/Mod parameters table that describes
their functions can be found on page 78.
VIEW Button
Pressing this button recalls the page of Sequencer parameters that was last used (it defaults to the
GRAPH page). Using this button to enter the Sequencer edit mode allows you to examine the
current settings without making any changes. You can, of course, change any setting but you
don’t have to when using a
VIEW button
Sequencer Parameters
This section describes the parameters of the Sequencer. The summary table below
shows the Sequencer’s parameter names – listed in the rows under under the
SOFT
KNOB
numbers – with their associated page (parameter group) in the PAGE TAB
column. The tables on the following pages provide operational details of each
display page.
SOFT KNOB
PAGE TAB
1 2 3 4 5 6 7 8
NOTE
VEL
ABCDEFGH
GATE
GRAPH
TYPE
IJKLMNOP
CONFIG LOCBPM KYTRIG LENGTH LPTYPE LPCNT MONLEG ZOOM USEKBD
TRIG SOURCE LEVEL TYPE RETRIG ENABLE TRGVOX MODE
PROGRS PRGRSR MIN MIX
SYNC SYNSRC STPSIZ
MOD SOURCE LEVEL OFFSET ENABLE
RUN
Pressing this button turns the sequencer on or off. This is the same as pressing the
START/STOP
button in the SEQUENCER section on the front panel.
1-16
Use soft button 8 to select a Step (
A – P) on the GRAPH page for editing.