Filter
Top Products
100
MR16 Owner’s Manual (MIDI synchronization)
The following describes how to synchronize a sequencer to the MR16 which supports MTC (MIDI
Time code).
Connect the [MIDI OUT] connector of the MR16 to the [MIDI IN] connector of an external MIDI se-
quencer using a MIDI cable. (Note that no MIDI cable is supplied with the MR16. Use a commercially
available MIDI cable.)
1) Set the "Midi Sync Out" item in the "System" menu of the menu mode to "MTC" and the "MTC Frame Rate"
to an appropriate frame rate.
See "MIDI sync/MTC frame rate settings" described below for details.
2) Enable the external MIDI sequencer to synchronize to MTC.
See the operation manual of the sequencer for details.
3) Press the [PLAY] key of the MR16 to start playback.
The sequencer automatically starts playback while synchronizing to the MR16.
USB
USB HOST
MIDI OUT
DIGITAL OUT
FOOT SW
INPUT A SEL
GTR CLEAN
MIC/LINE
GTR DIST
MIDI sequencer, etc.
Connection
Settings of the MR16 & MIDI sequencer
Synchronization using MTC
MIDI IN