Filter
Top Products
16
MR16 Owner’s Manual (Read this chapter first!)
[TRIM] control
You must pay great attention to the [TRIM] control adjustment when recording to the MR16.
The analog signal received at each input ([INPUT A] through [INPUT D]) is sent to the [TRIM]
control, by which the signal level fed to the A/D converter of the MR16 is controlled.
You can check this level by the PEAK indicator. If the level is too high, the PEAK indicator lights,
while you may hear the sound distorted or noisy. This distortion (noise) generated at this stage
cannot be eliminated, therefore, adjust the TRIM control properly so that the PEAK indicator
does not light at the loudest part of the input signal.
[TRIM] control
PEAK LED
Clipping level
Clipping level
Proper level
The level is too high.
PEAK
GUITAR
MIN
DISTORTION
MAX
LINE MIC
TRIM
INSERT/GUITAR
UNBAL
BALBALBALBAL
INPUT A INPUT B INPUT C INPUT D
VOLUME
MIN MAX
PEAK
LINE
TRIM
MIC
UNBAL UNBAL
MIC
TRIM
LINE
PEAK
UNBAL
MIC
TRIM
LINE
PEAK
ROOM
INPUT EQ
TO STEREO BUSS LEVEL
MIN MAX
MIN
MAX
REVERB / DELAY TIME
L
STEREO OUT
R
1
AUX OUT
2
1
PHONES
2
INPUT A INPUT B INPUT C INPUT D