Filter
Top Products
134
MR16 Owner’s Manual (Part editing)
You can move the desired part(s) of the desired track(s) to the other desired track(s).
The part move operation can be made only within the current song. After the part move opera-
tion is carried out, the source part(s) becomes silent.
<Note>:
You cannot move data of a song protected.
Release the protection before moving data.
1) Load the song you want to edit.
2) Set the LOCATE A and LOCATE B points (see
page 53).
You can check the part(s) by playing back
between the LOCATE A and LOCATE B points
(see page 48).
3) While the recorder is stopped, press the
[MENU/ENTER] knob to enter the menu mode.
The display now shows the first page of the
menu selection screen.
4) Rotate the [MENU/ENTER] knob to select
"Part Edit
", and press the [MENU/ENTER] knob.
The display now shows the part edit menu
screen.
5) Rotate the [MENU/ENTER] knob to select
"Move Part
", and press the [MENU/ENTER] knob.
The display now shows the screen for
selecting the source track(s) and destination
track(s) of the move operation.
6) Rotate the [MENU/ENTER] knob to select
"Source Track = *", and press the [MENU/ENTER]
knob.
You can now select the move source track(s)
by rotating the [MENU/ENTER] knob.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6, 7/8, 9/10, 11/12, 13/14 and 15/16
(stereo tracks)
Moving the part(s)
Locate A point
Locate B point
ABS ZERO
REC END
You can move the desired part(s) on the desired track(s) to the other desired track(s).
Flashing