Filter
Top Products
129
MR16 Owner’s Manual (Part editing)
You can copy the desired part(s) of the selected track(s) and paste it(them) to the same time
position of the other desired track(s). The copy/paste operation of a part or parts can be made
only within the current song. You can also make the copy/paste operation of a part or parts
using another method described later in "Copying/pasting the desired part(s)-2".
1) Load the song you want to edit.
2) Set the LOCATE A and LOCATE B points for
specifying the desired part(s) (see page 53).
You can check the part(s) by playing back
between the LOCATE A and LOCATE B points
(see page 48).
<Note>:
You cannot copy/paste track data of a song
protected. Release the protection before making
the copy/paste operation.
4) Rotate the [MENU/ENTER] knob to select
"Part Edit
", and press the [MENU/ENTER] knob.
The display now shows the part edit menu
screen.
<Note>:
If you want to paste the copied part(s) to
the desired time position of other track(s) other
than the position between the LOCATE A and LO-
CATE B points, use the method described later in
"
Copying/pasting the desired part(s)-2
".
9) After pressing the [MENU/ENTER] knob, press
the [STOP] key to exit the MENU mode.
<Note>:
If you are not satisfied with the re-
sult, press the [
UNDO/REDO
] key to undo the
operation (see page 127).
8) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR16
completes erasing.
If you want to cancel the part erase operation,
move the cursor to "[CANCEL]" on the screen,
and press the [MENU/ENTER] knob.
3) While the recorder is stopped, press the
[MENU/ENTER] knob to enter the menu mode.
The display now shows the first page of the
menu selection screen.
Copying/pasting the desired part(s)-1
Flashing
Locate A point
Locate B point
ABS ZERO
REC END
You can copy and paste the desired part(s) on the desired track(s) into the other desired track(s).