Filter
Top Products
135
MR16 Owner’s Manual (Part editing)
9) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR16
completes the move operation.
<Note>:
If you are not satisfied with the re-
sult, press the [
UNDO/REDO
] key to undo the
operation (see page 127).
8) Rotate the [MENU/ENTER] knob to select the
destination track(s), and press the
[MENU/ENTER] knob.
The display returns to the screen where
"Dest. Track = *" is highlighted.
If you want to cancel the move operation, move
the cursor to "[CANCEL]" on the screen, and
press the [MENU/ENTER] knob.
Flashing
Flashing
Flashing
7) Rotate the [MENU/ENTER] knob to select the
move source track(s), and press the
[MENU/ENTER] knob.
You can now select the move destination
track(s) by rotating the [MENU/ENTER] knob.
<Note>:
You cannot select the same track(s)
for the move source and destination.
10) After pressing the [MENU/ENTER] knob, press
the [STOP] key to exit the MENU mode.
You can select the same number of tracks as the
move destination track(s). For example, if you
select a mono track for the move source, you can
only select a mono track for move destination.