Filter
Top Products
23
MR16 Owner’s Manual (Names and functions)
30. [UNDO/REDO] key
Used to undo or redo recording or editing
(see pages 38, 40, 42, 119 and 127).
Each press of the key alternates "undo" and
"redo".
28. [STORE] key
Stores the current recorder position (time
data) as the LOCATE A/IN or LOCATE B/OUT
point (see page 53).
In the "2-mix file playback" mode, pressing this
key sets a CUE point to the current stereo
WAV file (see the supplementary manual
"How to use the CD-R/RW drive").
33. [LOCATE B/OUT] key
Pressing this key while holding down the
[STORE] key sets the LOCATE B point (or
punch out point) (see pages 53 and 62).
32. Transport keys
[PLAY] key
Starts playback of the recorder.
Pressing this key while holding down the
[RECORD] key starts recording of the armed
(record-ready) track(s).
Pressing this key during recording exits re-
cording.
Pressing this key in the direct locate mode
executes the preview playback for a few sec-
onds after the locate point (see page 58).
[STOP] key
Stops the recorder.
By pressing the [PLAY], [REWIND] or [F FWD]
key while holding down the [STOP] key, you
can locate to a specific point or repeat play-
back as below.
• [STOP] + [PLAY] (A-B PLAY)
Repeats playback between the LOCATE A and
LOCATE B points (see page 48).
• [STOP] + [REWIND] (LOCATE ABS ZERO)
Locates to the beginning (ABS ZERO) of the
current song (see page 52).
• [STOP] + [F FWD] (LOCATE REC END)
Locates to the recording end of the current
song (REC END) (see page 52).
[RECORD] key
Pressing the [PLAY] key while holding down
the [RECORD] key starts recording of the
armed (record-ready) track(s).
By pressing only the [RECORD] key when any
track(s) is armed (in record-ready), the in-
put signal(s) of the armed track(s) can be
monitored (i.e. input monitor mode). (see
pages 37 through 42).
Pressing this key in the direct locate mode
executes the preview playback for a few sec-
onds before the locate point (see page 58).
[F FWD] key
Pressing this key fast forwards the recorder.
During playback, pressing this key starts 3 x
cueing (see page 48).
While holding down the [STOP] key, press-
ing this key locates to the recording end of
the current song (REC END) (see page 52).
[REWIND] key
Pressing this key rewinds the recorder.
During playback, pressing this key starts 3 x
reverse cueing (see page 48).
While holding down the [STOP] key, press-
ing this key locates to the beginning (ABS
ZERO) of the current song (see page 52).
This key is also used to go up the menu
screen layer while a menu screen is dis-
played.
34. [LOCATE A/IN] key
Pressing this key while holding down the
[STORE] key sets the LOCATE A point (or
punch in point) (see pages 53 and 62).
35. [PLAY MODE] key
Selects a play mode. You can select from
among normal, auto play, auto return and
loop (see page 49).
36. [AUTO PUNCH] key
Turns on or off the auto punch mode (see
page 63).
29. [CONTRAST] key
By rotating the [MENU/ENTER] knob while
holding down this key, you can adjust the
display contrast (see page 27).
37. Insert effect selection keys
Used to select the insert effect (mic simula-
tion or amp simulation) for the signal from
the [INPUT A] jack.
When setting the [INPUT A SELECT] switch
on the rear panel to "MIC/LINE", you can use
the mic simulation effect. When setting the
switch to "GTR/DIST", you can use the guitar
amp simulation effect (see page 68).
31. [DIRECT LOCATE] key
Each press of this key alternates ON and OFF
of the direct locate mode (see page 55).