Filter
Top Products
32
MR16 Owner’s Manual (Basic operations)
In the demo song, approximately 1-minute audio is recorded on all eight tracks. Follow the procedure
below for listening to the demo song. In the following procedure, it is assumed that the MR16 is
turned on and a pair of headphones (or a monitor speaker system) is connected.
Playing back the demo song
<Hint-2>: To listen to the demo song again:
When the recorder is stopped after listen-
ing to the demo song, press the [REWIND]
key while holding down the [STOP] key.
The recorder instantly moves back to the
beginning of the demo song (see page 52).
Then pressing the [PLAY] key starts play-
back from the beginning of the demo song.
<Note>:
The demo song is protected and you can-
not overwrite or erase it. Therefore, you cannot
make recording in this condition.
If you want to make new recording while keep-
ing the demo tape on the hard disk, see "Creat-
ing a song for recording" on the next page.
If you do not keep the demo song, carry out ei-
ther of the following operations.
(1) Release the song protection (see page
117).
Then, start recording (overwrite
recording) from the beginning of the demo
song, or delete the demo song from the
hard disk (see page 116). If you delete the
demo song, create a new song (see the next
page) and make recording to the new song.
(2) Format the hard disk (see page 140) and
make recording.
Because a new song is automatically
created after formatting the disk, you can
start recording without the need of
creating a new song manually.
1) Raise the [MASTER] fader to the " " position.
Set the track faders at the lowest position.
2) Press the [PLAY] key to start playback.
3) Raise the track faders (1 through 8) gradually to
adjust the playback level and balance.
Also raise the [PHONES VOL] control gradually
to adjust the headphones level. (If you are
using a powered monitor speaker for
monitoring, adjust the level control of the
powered speaker.)
4) When the demo song ends, press the [STOP] key
to stop the recorder.
<Hint-1>:
While listening to the playback
sound, adjust panning setting of tracks 1
through 8, as well as try to adjust the inter-
nal effects (reverb/delay) (see page 70).
PEAK
GUITAR
MIN
DISTORTION
MAX
LINE MIC
TRIM
INSERT/GUITAR
UNBAL
BALBALBALBAL
INPUT A INPUT B INPUT C INPUT D
VOLUME
MIN
MAX
PEAK
LINE
TRIM
MIC
UNBAL
POWER
UNBAL
MIC
TRIM
LINE
PEAK
UNBAL
MIC
TRIM
LINE
PEAK
MAX
MIN
1
R
L
100
SIMULATION
SIMULATION
AMP
MIC
010
LR
010
LR
2
3
RL
100
4 8
010
LR
7
6
RL
100
RL
100
010
LR
5
MAX
MIN
MASTER
REC SELECT
RECORD STOP PLAY
REWIND F FWD
UNDO/REDO
STORE
LOCATE REC END
LOCATE ABS ZERO
A-B PLAY
BOUNCE
MASTERING
BRIGHT
15/16 > STEREO WAV FILE
NATURAL
POWERFUL
B / OUTA / INPLAY MODEAUTO PUNCH
LOCATE
EFFECT
DELAYPLATEHALLROOM
BOUNCE MODE
CONTRAST
TIMEBASE SELECT
RHYTHM GUIDE DIRECT LOCATE
EFFECT SEND
PAN
INPUT EQ
TO STEREO BUSS LEVEL
9/10 11/12 13/14 15/16
ABC1 DEF2
GHI3 JKL4
MNO5 YZ9PQR6 +-_0STU7 VWX8 DELETE
MENU / ENTER
MIN MAX
MIN
MAX
REVERB / DELAY TIME
L
STEREO OUT
R
1
AUX OUT
2
1
PHONES
2
DYNAMIC BRIT STACK
CONDENSER
US METAL
TUBE
60'S COMBO
INPUT A INPUT B INPUT C INPUT D
1
2
1,3
3
4
Hint-2
Hint-1