Filter
Top Products
131
MR16 Owner’s Manual (Part editing)
You can copy the desired part(s) of the selected track(s) and paste it(them) to the other time
position of the desired track(s). Unlike the method described above in "Copying/pasting the de-
sired part(s)-1", the part data is copied to the (virtual) clipboard and then pasted to the specified
position of the other specified track(s).
The copy/paste operation of a part or parts can be made only within the current song.
<Note>:
You cannot copy/paste track data of a song
protected. Release the protection before making
the copy/paste operation.
<Note>:
If you paste the part(s) to the same time
position of the other track(s), we recommend us-
ing the method described above in "
Copying/past-
ing the desired part(s)-1
", because it works faster.
Copying/pasting the desired part(s)-2
10) After pressing the [MENU/ENTER] knob, press
the [STOP] key to exit the MENU mode.
<Note>:
If you are not satisfied with the re-
sult, press the [
UNDO/REDO
] key to undo the
operation (see page 127).
<Note>:
If you turn off the MR16 after copying
the part data to the clipboard, the data on the
clipboard is lost. Also note that you cannot undo
copying data to the clipboard.
Locate A point
Locate B point
ABS ZERO
REC END
Locate A point
ClipBoard (Virtual)
1) Load the song you want to edit.
2) Set the LOCATE A and LOCATE B points (see
page 53).
You can check the edited part(s) by playing
back between the LOCATE A and LOCATE B
points (see page 48).
Copying to the clipboard
<Note>:
You cannot undo/redo copying to the clip-
board.
Firstly, you must copy the desired part data to the
clipboard.
You can copy and paste the desired part(s)
on the desired track(s) into the desired time
position on the other desired track(s).