Filter
Top Products
86
MR16 Owner’s Manual (Track bouncing)
The default panning settings are as below.
You can set each input to the desired panning
position from L10 (hard left) to R10 (hard
right).
Input A
CNT (center position)
Input B
CNT (center position)
Input C
CNT (center position)
Input D
CNT (center position)
3) Rotate the [MENU/ENTER] knob to select the
desired item (any one of "Input A Pan" through
"Input D Pan"), and press the [MENU/ENTER] knob.
You can select the desired panning value from
among R01 through R10 and L01 through L10,
as well as "CNT" (center).
4) Rotate the [MENU/ENTER] knob to select the
desired value, and press the [MENU/ENTER] knob.
The panning is set and the display returns to the
previous screen.
In the screen example below, "Input A Pan" is set
to "R10".
You can also make panning setting of another
input in the same manner as above.
5) Press the [STOP] key to exit the menu mode.
By selecting " Back" and pressing the
[MENU/ENTER] knob, the display returns to the
previous screen.
Therefore, you can also exit the menu mode
by repeating this operation.
<Tip>: You can directly access to the input
menu screen by a long press of the [TO STE-
REO BUSS] key of the desired input chan-
nel. On the input menu screen accessed in
this way, the panning setting item for the
corresponding input is highlighted.
For example, a long press of the [TO STE-
REO BUSS] key of [INPUT D] directly accesses
to the screen shown below.
Panning setting for INPUT A through INPUT D
1) While the recorder is stopped, press the
[MENU/ENTER] knob to enter the menu mode.
The display now shows the first page of the
menu selection screen.
2) Rotate the [MENU/ENTER] knob to select "Input "
on the second page, and press the [MENU/ENTER]
knob.
The display now shows the input menu screen.
You can independently set panning for each of INPUT A through INPUT D.
Each input signal is positioned in the mix according to the panning setting here.
The display shows the screen for making pan-
ning setting of the selected input. The current
setting flashes.
In the screen example below, "Input A Pan" is se-
lected and the default "CNT" is flashing.
Flashing
Flashing
Flashing