Filter
Top Products
137
MR16 Owner’s Manual (Part editing)
8) Rotate the [MENU/ENTER] knob to select the
destination track(s), and press the
[MENU/ENTER] knob.
The display shows the screen where
"Dest. Track = **" is highlighted.
<Note>:
If you are not satisfied with the re-
sult, press the [
UNDO/REDO
] key to undo the
operation (see page 127).
9) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR16
completes the exchange operation.
If you want to cancel the exchange operation,
move the cursor to "[CANCEL]" on the screen,
and press the [MENU/ENTER] knob.
Flashing
Flashing
Flashing
7) Rotate the [MENU/ENTER] knob to select the
source track(s) to be exchanged, and press the
[MENU/ENTER] knob.
You can now select the exchange destination
track(s) by rotating the [MENU/ENTER] knob.
<Note>:
You cannot select the same track(s)
for the exchange source and destination.
You can select the same number of tracks as the
exchange destination track(s). For example, if you
select a mono track for the exchange source, you
can only select a mono track for exchange desti-
nation.
10) After pressing the [MENU/ENTER] knob, press
the [STOP] key to exit the MENU mode.