Filter
Top Products
105
MR16 Owner’s Manual (Data export to a personal computer)
1) While the recorder is stopped, press the
[15/16 > STEREO WAV FILE] key to enable the
file conversion function.
The display shows the "15/16 > STEREO WAV
FILE" screen, on which "ABS0-Rec End" is
highlighted.
The following assumes that the song whose track data you want to convert is loaded.
To convert all track data, select "ABS0-Rec End".
To convert a specified range, select "LOCATE A
- LOCATE B".
2) Press the [MENU/ENTER] knob.
"ABS0-Rec End" starts flashing, and you can
now select the conversion range between
"ABS0-Rec End" and "LOCATE A - LOCATE B".
3) Rotate the [MENU/ENTER] knob to select the
conversion range and press the [MENU/ENTER]
knob.
The selection is confirmed and the display
returns to the previous screen.
Procedure of file conversion
"NAME = *********" shows the name for the con-
verted file, and you can enter a desired name.
Initially, it shows the name of the source file,
therefore, if you do not change the name, the
same file name is given.
The following assumes that the file name is not
changed. For details about how to edit a name,
see "Editing a file name" on the next page.
When you convert data in the same song more
than once, you have to give a different name
for each converted file. See the <Note> on the
next page.
Flashing
5) Press the [MENU/ENTER] knob.
The MR16 quits the conversion function and
the display returns to the home screen.
<Note>:
If you convert data with the same
name as previously converted data, the fol-
lowing screen appears on the display.
This screen warns you that the WAV file with
the same name already exists and asks you
to carry out the conversion by overwriting
the existing file or cancel the conversion.
If you carry out the conversion by overwrit-
ing the existing file, rotate the [
MENU/EN-
TER
] knob to move the cursor to "
[YES]
",
and press the [
MENU/ENTER
] knob.
If you do not want to overwrite the existing
file, rotate the [
MENU/ENTER
] knob to move
the cursor to "
[NO]
", then press the [
MENU/
ENTER
] knob. The display returns to show
the screen for editing the file name, so you
can enter a different file name and then
carry out the conversion.
If you want to cancel the conversion when
the screen above is shown, rotate the [
MENU/
ENTER
] knob to move the cursor to "
[NO]
"
and press the [
MENU/ENTER
] knob to show
the screen for editing the file name, and then
press the [
STOP
] key to quit the conversion
function.
When the conversion is completed, the display
shows "Completed".
<Note>:
If you cancel the conversion in the
middle, no file (incomplete file) is created.
4) Press the [MENU/ENTER] knob while holding
down the [RECORD] key.
The file conversion starts and the percent
number on the screen counts up as the
conversion progresses.
To cancel the conversion in the middle, press
the [STOP] key.