Filter
Top Products
154
MR16 Owner’s Manual (Troubleshooting)
<Trouble 3>: The input level of the track to which I am going to record is too low.
• Is the [TRIM] control of the input to which the sound source is connected
adjusted appropriately?
To set the input level (= recording level) appropriately, use the [TRIM] control so
that the peak indicator does not light continuously.
<Trouble 1>: I cannot record the sound source connected to [INPUT B] to track 1.
• When recording a sound source to a mono track, you can only use the
[INPUT A] section.
Connect the source to [INPUT A].
<Trouble 2>: I cannot record the sound sources connected to [INPUT C] and [INPUT D]
to tracks 1 and 2.
• When recording two sound sources simultaneously, you must use
[INPUT A] and [INPUT B]. You cannot use [INPUT C] and [INPUT D].
Reconnect the sources to [INPUT A] and [INPUT B].
<Trouble 4>: I cannot hear the input signal via the headphones though the
[REC SELECT] key is active.
• Did you press the [RECORD] key to make the armed track in the input
monitor mode? Is the [PHONES VOL] control raised?
You cannot hear the input signal unless the assigned track is in the input monitor
mode by pressing the corresponding [REC SELECT] key to turn on the indicator.
Also, you cannot hear any signal if the [PHONES VOL] control is set to minimum.
Troubles for recording
<Trouble 5> : The meter shows very low level and the recording level is too low.
• Is the [TRIM] control for the input section the sound source is connected
adjusted appropriately?
Set the [TRIM] control just below the position where the [PEAK] indicator in the
[INPUT A] section lights at the loudest part.