Filter
Top Products
150
MR16 Owner’s Manual (Application examples)
This example uses the AUX OUT and TO STEREO BUSS functions. It is assumed that you want to
do the following.
(1) When mixing down tracks 1 through 16, you want to insert a delay effect to track 8 using an external
delay unit.
(2) You also want to insert an amplifier simulation effect to track 4 using an external amplifier simulator.
Application example 1 (Mixing)
Connection between the MR16 and external units
PEAK
GUITAR
MIN
DISTORTION
MAX
LINE MIC
TRIM
INSERT/GUITAR
UNBAL
BALBALBALBAL
INPUT A INPUT B INPUT C INPUT D
VOLUME
MIN
MAX
PEAK
LINE
TRIM
MIC
UNBAL
POWER
UNBAL
MIC
TRIM
LINE
PEAK
UNBAL
MIC
TRIM
LINE
PEAK
BOUNCE
15/16 > STEREO WAV FILE
EFFECT
DELAYPLATEHALLROOM
BOUNCE MODE
INPUT EQ
TO STEREO BUSS LEVEL
MENU / ENTER
MIN MAX
MIN
MAX
REVERB / DELAY TIME
L
STEREO OUT
R
1
AUX OUT
2
1
PHONES
2
INPUT A INPUT B INPUT C INPUT D
Master recorder
Delay unit
Amplifier simulator
Operation procedure
• Set the output source of AUX OUT 1 to track "8".
• Set the output source of AUX OUT 2 to track "4".
See page 146 for details about how to make
settings above.
• Set the panpot of INPUT A to "L10".
• Set the panpot of INPUT B to "R10".
• Set the panpot of INPUT C to "CNT".
See page 86 for details about how to make
settings above.
• Use the [To STEREO BUSS LEVEL] control to adjust
the effect (wet) sound level.
• Use the faders for tracks 1 through 16 to adjust the
track signal levels.
The output levels of AUX OUT 1 and AUX OUT 2
are fixed and not affected by the corresponding
track fader settings.
<Notes>
•
You can independently assign any one of tracks 1
through 16, the effect send and the internal click
to AUX OUT 1 and AUX OUT 2 (you cannot assign
more than one signal to each AUX OUT).
•
You can set pan for each of INPUT A through D at
the desired position between L10 and R10.
•
The mixing levels of INPUTs A through D are
collectively controlled by the [TO STEREO BUSS
LEVEL] control.
•
The balance among INPUTs A through D is
adjusted using the TRIM control for each input
channel or the output level control of each
external device. If you do not want to mix any of
the input channels, you can mute it.
•
The input channel which is assigned to a recorder
track for recording is not mixed.
• Turn on the [TO STEREO BUSS] keys for [INPUT A]
through [INPUT C].