Filter
Top Products
133
MR16 Owner’s Manual (Part editing)
<Note>:
If you are going to carry out the
paste operation when no data is pasted on
the clipboard, the error message (“
Clipboard
Empty!
) is shown on the display and the
MR16 does not accept the operation.
Press the [
STOP
] key to exit the menu mode
and copy the desired data to the clipboard
before carrying out the paste operation.
<Note>:
If you are not satisfied with the re-
sult, press the [
UNDO/REDO
] key to undo the
operation (see page 127).
3) Rotate the [MENU/ENTER] knob to select the
paste destination track(s), and press the
[MENU/ENTER] knob.
The display returns to the previous screen.
4) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR16
completes the paste operation.
If you want to cancel the part paste operation,
move the cursor to "[CANCEL]" on the screen,
and press the [MENU/ENTER] knob.
Flashing
Flashing
The following procedure is assumed that the
LOCATE A point, the paste destination, is set
Pasting clipboard data
1) Rotate the [MENU/ENTER] knob to select
"Paste Part >", and press the [MENU/ENTER] knob.
The display now shows the screen for
selecting the paste destination track(s).
2) Rotate the [MENU/ENTER] knob to select
"Paste Track = *", and press the [MENU/ENTER]
knob.
You can now select the desired paste destination
track(s) by rotating the [MENU/ENTER] knob.
5) After pressing the [MENU/ENTER] knob, press
the [STOP] key to exit the MENU mode.
You can select the same number of tracks as the
paste destination track(s). For example, if you
select a mono track for the copy source, you can
only select a mono track for paste destination.