Roland GR-55 Electronic Keyboard User Manual


 
57
Patch Settings (MASTER)
Tab Parameter Value Description
EXP,
EXP ON,
GK VOL
FUNCTION MOD CONTROL
Controls the principal parameter for each type of MOD eect.
This is valid if MOD SWITCH is “ON.”
MOD CONTROL
Parameter
Value Description
MIN
Species the range of change for the parameter. The values will depend on the
parameter that’s assigned by MOD type.
MAX
MOD Type Parameter MOD Type Parameter
OD/DS DRIVE TREMOLO RATE
WAH (*1) PEDAL POSITION ROTARY SPEED SELECT
COMP SUSTAIN UNI-V RATE
LIMITER THRESHOLD PAN RATE
OCTAVE OCTAVE LEVEL DELAY EFFECT LEVEL
PHASER RATE CHORUS EFFECT LEVEL
FLANGER RATE EQ HI-MID FREQ
(*1) Set the MODE parameter (p.43) to “MANUAL.”
ASSIGN
Tab Parameter Value Description
ASSIGN
1–8
SWITCH OFF, ON Turns ASSIGN 1–8 on/o.
TARGET
Selects the parameter that will be controlled. For details on the parameters, refer to the explanations of each parameter in this
manual.
TARGET MIN
Species the range of change for the parameter. The values will depend on the parameter that’s assigned by TARGET.
TARGET MAX
SOURCE
Selects the controller to which the function will be assigned.
CTL [CTL] pedal
EXP Expression pedal
EXP ON Expression pedal when the expression pedal switch is on
EXP SW Expression pedal switch
INT PDL Internal pedal (p.62)
WAVE PDL Wave pedal (p.62)
GK S1 [S1] button of the GK pickup
GK S2 [S2] button of the GK pickup
GK VOL Volume knob of the GK pickup
CC1–31,
CC64–95
Control change number from an external MIDI device
SOURCE MODE
Species how the value will change for each operation.
MOMENT
The value will normally be o (minimum value), and will be on (maximum value) only while the
control is being operated.
TOGGLE The value will toggle between o (minimum) and on (maximum) each time the control is operated.
ACT RANGE LO 0–126 Within the operating range of the source, this species the range that will control the target
parameter.
The target parameter will be controlled within the range specied by ACT RANGE LO and ACT
RANGE HI. Normally, you should leave ACT RANGE LO at “0” and ACT RANGE HI at “127.”
ACT RANGE HI 1–127