Filter
Top Products
61
Controller Assignments
Controllers Whose Assignment Can
Be Changed
For the following controllers, you are free to change the operation that
will occur when they are pressed.
Expression pedal
[CTL] pedal
[S1]/[S2] buttons,
GK volume
Making a Pedal Have the Same Operation
for All Patches
When the GR-55 is shipped, each patch assigns the pedals to the
functions that are most useful for that particular patch. If you want
a pedal to have the same function regardless of the patch that is
selected, proceed as follows.
1. In the system parameter PEDAL/GK CTL section, change the
setting of the desired controller (CTL, EXP, EXP ON, EXP SW,
GK S1/S2, GK VOL) to other than “PATCH SETTING.”
For details on how to set system parameters, refer to “Settings for the
Entire GR-55 (SYSTEM)” (p.69).
Example setting
Switch delay on/o by pressing the [CTL] pedal
Make the following parameter settings.
• SYSTEM
PEDAL/GK CTL
Tab Parameter Value Page
CTL FUNCTION DELAY SW p.76
MEMO
You should rst raise the “EFFECT LEVEL” (p.52) setting for DELAY.
Changing the Pedal Assignments for Each
Patch
1. In the system parameter PEDAL/GK CTL section, change the
setting of the desired controller (CTL, EXP, EXP ON, EXP SW,
GK S1/S2, GK VOL) to “PATCH SETTING.”
For details on how to set system parameters, refer to “Settings for the
Entire GR-55 (SYSTEM)” (p.69)
2. Select the patch whose pedal assignment you want to
change (p.16).
3. In the EDIT screen, choose the MASTER tab and then the
PEDAL/GK CTL icon, and change the assignment of the
desired controller (CTL, EXP, EXP ON, EXP SW, GK S1/S2, GK
VOL) to the desired setting.
For details on how to set master parameters, refer to “Patch Settings
(MASTER)” (p.54).
4. Save the patch (p.60).
Example setting
When a specic patch is selected, use the expression pedal
to control the volume of the modeling tone
Select the patch whose settings you want to edit, then make the
following parameter settings.
Also be sure to verify that the tone switch (p.23) of the modeling tone is
turned on.
• SYSTEM
PEDAL/GK CTL
Tab Parameter Value Page
EXP FUNCTION PATCH SETTING p.77
• MASTER
PEDAL/GK CTL
Tab Parameter Value Page
EXP FUNCTION
TONE VOLUME
p.56
PCM TONE 1: OFF
PCM TONE 2: OFF
MODELING TONE: ON
NORMAL PU: OFF