Filter
Top Products
63
Controller Assignments
Example setting 2
For guitar solos, you want to be able to step on the [CTL]
pedal to switch AMP to solo mode
Select the patch whose settings you want to edit, and then make the
following parameter settings.
• SYSTEM
PEDAL/GK CTL
Tab Parameter Value Page
CTL FUNCTION PATCH SETTING p.76
• MASTER
ASSIGN
Tab Parameter Value Page
ASSIGN 1
SWITCH ON
p.57
TARGET AMP “SOLO SW”
TARGET MIN OFF
TARGET MAX ON
SOURCE CTL
SOURCE MODE TOGGLE
ACT RANGE LO 0
ACT RANGE HI 127
ASSIGN 2
SWITCH ON
p.57
TARGET AMP “GAIN SW”
TARGET MIN LOW
TARGET MAX MID
SOURCE CTL
SOURCE MODE TOGGLE
ACT RANGE LO 0
ACT RANGE HI 127
NOTE!
If you edit the value of a parameter that’s assigned to a controller,
and then save the patch, some parameters will be overwritten with
the initial state of the controller. This will make it seem as though
the edited value has not been saved.
To avoid this situation, choose the OFF setting for the PEDAL/GK
CTL parameter FUNCTION (p.55, p.76) and for the ASSIGN parameter
SWITCH (p.57) of the function being assigned.