Filter
Top Products
4.5 KX-TD Series PBX Programming for DPT Integration
118 Installation Manual
4.5 KX-TD Series PBX Programming for DPT
Integration
For KX-TD500 programming, refer to 4.6 KX-TD500 PBX Programming for DPT Integration.
Programming procedures and availability may vary by country/area, software version, etc.
Refer to the documentation included with the PBX or consult your dealer for more information.
Note
• Do not use system programs [106] or [602] for DPT Integration.
• The next 2 sections (4.5.1 KX-TD Series PBX Programming via the Manager's Extension
and 4.5.2 KX-TD1232 Series PBX Programming via the Operating and Maintenance Tool)
use the KX-TD1232 as an example. Refer to these examples when configuring the KX-
TD612 and KX-TD816.
4.5.1 KX-TD Series PBX Programming via the Manager's
Extension
For KX-TD500 programming, refer to 4.6 KX-TD500 PBX Programming for DPT Integration.
It is important that the PBX has the proper software level to allow DPT Integration with the VPS.
Follow the procedures below to confirm the software level, then complete the required programming
before starting up the VPS.
Note
• There are 2 methods of programming available for the KX-TD1232. The instructions below
show how to program without the operating and maintenance tool. For instructions on
programming with the operating and maintenance tool, please see 4.5.2 KX-TD1232 Series
PBX Programming via the Operating and Maintenance Tool.
All of the following procedures must be performed through system programming. Refer to the
KX-TD1232 Programming Guide or Installation Manual for instructions on how to enter the
system programming mode.
Software Verification
1.
Verify Software—If you are configuring a 2-cabinet system, remember to check both cabinets.
The software must be the same in each. Check the software version of the KX-TD1232 using
System Program [116].
Example: P231U60403
XX
The underlined digits represent the software production date code (year, month, day). For DPT
Integration, the production date must be 60403 or later.
If the software version of the PBX is lower than this, you may not be able to utilise some
of the features available only with DPT Integration. For more information, consult your
dealer.
From the SYS-PGM NO ? screen:
a) Enter [116].
b) Press the NEXT button (SP-PHONE).