Filter
Top Products
7.6 Troubleshooting
Installation Manual 229
Unable to access to
Operator 1
• Improper setting of the
operator extension number.
• Adjust the operator extension
number to that of the
connected PBX (see
"Operator's Extension" in
2.4.3 Parameters in the
Programming Manual).
Unable to make
reconnection when the line
is busy.
• Improper setting of the busy
signal reconnection
procedure.
• Adjust the busy signal
reconnection procedure to
that of the connected PBX
(see "Reconnect Sequence on
Busy" in 2.5.4 Parameters in
the Programming Manual).
Unable to make a no-
response reconnection.
• Improper setting of the no-
response reconnection
procedure.
• Adjust the no-response
reconnection procedure to
that of the connected PBX
(see "Reconnect Sequence on
No Answer" in 2.5.4
Parameters in the
Programming Manual).
Unable to generate a call
waiting tone from the VPS.
• Improper setting of sequence. • Adjust the Call Waiting
sequence to that of the
connected PBX (see "Call
Waiting Sequence" in 2.5.4
Parameters in the
Programming Manual).
Unable to make an Intercom
Paging for groups.
• Improper setting of the
Intercom Paging access
code.
• Adjust the Intercom Paging
access code to that of the
connected PBX (see "Paging
Code" in 2.5.4 Parameters in
the Programming Manual).
PROBLEM PROBABLE CAUSE POSSIBLE SOLUTION