Filter
Top Products
5.2 PBX Settings for Inband Integration
158 Installation Manual
Inband Signalling
These parameters are used when the Integration Mode is set to Inband. If the PBX type is set to a
KX-T series system, these parameters will be automatically set. If another type of PBX is used, check
the system's Installation Manual for settings.
Digit Translation Table Parameters
These parameters allow PBXs that have a fixed Follow-on ID sequence to be used with the VPS. For
example, a Follow-on ID sequence of [ 1001] can be changed to [#61001] by using these
parameters.
• Inter-Digit Time-out
This parameter defines the interval of incoming signals (Follow-on ID) from the PBX to the
VPS.
• Translation Table
When the system receives digits within the inter-digit time, it checks them against the input
table. If they are found, the VPS translates the digits according to the table.
Code
(default)
Call State Sent to the Voice Mail Port When...
1 Ringback Tone The extension dialled is ringing.
2 Busy Tone The extension dialled is busy.
3
Reorder Tone An invalid extension number is dialled or the call is
inadvertently connected to another Voice Mail port (also
heard when no DTMF receiver is available to the Voice Mail
extension).
4 DND The extension dialled has set the Do Not Disturb feature
(DND).
5 Answer The extension dialled is answered.
6
Forwarded to Voice
Mail (Ringing)
The extension dialled is forwarded to Voice Mail and another
Voice Mail port is able to answer. (This lets the first Voice
Mail port, usually an Auto Attendant, send the call to the
other Voice Mail port.)
7
Forwarded to Voice
Mail (Busy)
The extension dialled is forwarded to Voice Mail and no
other Voice Mail ports are available to accept the call. (This
signals the Voice Mail port, usually Auto Attendant, to let the
caller leave a message.)
8
Forwarded to Extn. The extension dialled is forwarded to another non-Voice
Mail extension.
9
Confirmation Tone The Message Waiting Lamp On or Message Waiting Lamp
Off code is dialled successfully.
#9
Disconnect The caller disconnects. The telephone company must set a
CPC signal to the PBX line for this signal to work for trunk
calls.