Filter
Top Products
5.5 KX-TD Series PBX Programming for Inband Integration
Installation Manual 175
5.5 KX-TD Series PBX Programming for Inband
Integration
For KX-TD500 programming, refer to 5.6 KX-TD500 PBX Programming for Inband Integration.
DPT Integration is recommended when using the VPS with the KX-TD612, KX-TD816, or KX-
TD1232, however, Inband Integration is necessary when the software version of the PBX does not
support DPT Integration.
Programming procedures and availability may vary by country/area, software version, etc.
Refer to the documentation included with the PBX or consult your dealer for more information.
5.5.1 KX-TD Series PBX Programming via the Manager's
Extension
For KX-TD500 programming, refer to 5.6 KX-TD500 PBX Programming for Inband Integration.
Select a maximum of 2 extension ports to be connected to the VPS. Plug each extension into a Voice
Mail port.
Go to System Program [602] and assign the Voice Mail extensions to a different extension group. By
default, all extensions are in Extension Group 1.
Go to System Program [106] and assign the new Extension Group to Auto Attendant (AA). Then go
to System Program [813] and assign a floating number to the hunting group.
If your KX-TD816 or KX-TD1232 supports System Program [131] (Hunting Group Assignment),
program as follows.
Go to System Program [131] and enter the Voice Mail extensions into a hunting group.
Go to System Program [106] and assign the hunting group to Auto Attendant (AA).
Then go to System Program [813] and assign a floating number to the hunting group.
5.5.2 KX-TD Series PBX Programming via the Operating and
Maintenance Tool
For KX-TD500 programming, refer to 5.6 KX-TD500 PBX Programming for Inband Integration.
1. Go to the Main Menu. Choose "System Data Programming".
(BATCH [1] or INTERACTIVE [2]).
• Before choosing Batch Programming, you must open a file in the Disk File Management
Menu (Item 3).
• Before choosing Interactive Programming, you must connect with the system in the
DSHS Connect/Disconnect menu.