Filter
Top Products
121
Program operating mode
Page 18 - LFO2
Here is how “Fade In” affects the LFO (when “Key Sync” is
On):
00…99 Fade rate.
Frequency MIDI/Tempo Sync
MIDI/Tempo Sync
This parameter enables/disables the LFO synchronization
with Sequencer 1 Tempo.
On The LFO frequency will synchronize to the
tempo (MIDI Clock) of Sequencer 1. In this
case, the values you specified for “Frequency”
(see page 14-120) and “Frequency modula-
tion” (see page 14-121) will be ignored.
Base Note/Times
When “MIDI/Tempo Sync” is On, these parameters set a note
length relative to “ (Tempo)” and the multiple (“Times”)
that will be applied to it. These parameters will determine the
frequency of the LFO1. For example if “Base Note” is (quar-
ter note) and “Times” is 04, the LFO will perform one cycle
every four beats.
Even if you change the “ (Tempo)” setting of Sequencer 1,
the LFO will always perform one cycle every four beats.
Base Note
This parameter is not available when editing a Drum Pro-
gram.
, , , , , , ,
Note value.
Times
This parameter is not available when editing a Drum Pro-
gram.
01...16 Beats before restarting the cycle.
Frequency modulation
You can use two alternate modulation sources to adjust the
speed of the LFO1 for the selected oscillator.
AMS1(F) (Alternate Modulation Source1)
Selects the source that will adjust the frequency of the
selected oscillator LFO1 (see “AMS (Alternate Modulation
Source) list” on page 123). LFO1 can be modulated by LFO2.
Intensity (AMS1 Intensity)
This parameter specifies the depth and direction of the effect
that “AMS1(F)” will have. When this parameter is set to a
value of 16, 33, 49, 66, 82, or 99, the LFO frequency being can
be increased by a maximum of 2, 4, 8, 16, 32, or 64 times
respectively (or decreased by 1/2, 1/4, 1/8, 1/16, 1/32, or 1/64
respectively).
For example, if “AMS1(F)” is Note Number, positive (+) val-
ues of this parameter will cause the oscillator LFO to speed
up as you play higher notes. Negative (–) values will cause the
oscillator LFO to slow down as you play higher notes. This
change will be centered on the C4 note.
If “AMS1(F)” is set to JS +Y, raising the value of this parame-
ter will cause the oscillator LFO1 speed to increase as the joy-
stick is moved away from yourself. With a setting of +99,
moving the joystick all the way away from yourself will
increase the LFO speed by approximately 64 times.
-99…+99 Intensity value.
AMS2(F) (Alternate Modulation Source2)
Intensity (AMS2 Intensity)
Make settings for a second alternate modulation source that
will adjust the frequency of the oscillator LFO1 (see above
“AMS1(F) (Alternate Modulation Source1)” and “Intensity
(AMS1 Intensity)”).
PAGE 18 - LFO2
Here you can make settings for the LFO2, which is the second
LFO that can be applied to the selected oscillator. See “Page
17 - LFO1” for more information on the parameters value.
However in “Frequency modulation”, the LFO cannot be
selected as a modulation source in “AMS1” or “AMS2.”
PAGE 19 - EFFECTS
Here you can select two effects for the whole Program, switch
them on/off, and specify chaining.
Note: For details on the effects, refer to the “Effects” chapter.
FX1/2
Use these parameters to select the effect type for effect 1/2.
See the “Effects” chapter for more information.
Note: If 000: No Effect is selected, the output from the master
effect will be muted.
Send
Send level for each effect.
Drum samples have their own send level settings (see
“Send FX1” and “Send FX2” on page 14-109). Use this
parameter to adjust the general offset of the Drum Pro-
gram.
000…127 Effect level.
Chain 2>1
Use this parameter to send the output of effect 2 to the input
of effect 1.
000…127 Level of the signal exiting the effect 2 going
back to the effect 1.
Send to Master
This parameters allows you to decide if the direct + effected
signal must go to the Master, or just the effected signal.
Yes Only the effected signal will be sent to the
Audio Outputs. The direct (non-effected) sig-
nal will not be sent.
Note-on Note-off
Fade
Delay
FX1: 53 RecSmthHall
Send: 56
FX2: 16 Chorus
Send: 0
Effects