Filter
Top Products
183
Effects
Filter/Dynamic
012: Sub Oscill
(Stereo Sub Oscillator)
This effect adds very low frequencies to the input signal. It is
very useful when simulating a roaring drum sound or
emphasizing powerful low range. This effect is different from
the equalizer in that you can add very low range harmonics.
You can also adjust the oscillator frequency to match a partic-
ular note number, for use as an octaver.
a: OSC Mode, b: Note Interval, b: Note Fine
The “OSC Mode” parameter selects the oscillator opera-
tion mode. When Note (Key Follow) is selected, the oscil-
lator’s frequency is determined based on the note
number, allowing you to use it as an octaver. The “Note
Interval” parameter sets the pitch offset from the original
note number by semitone steps. The “Note Fine” parame-
ter allows you to fine-tune in steps of cents.
d: Envelope Pre LPF
This parameter sets the upper limit of the frequency range
to which very low harmonics are added. Adjust this
parameter if you do not want to add lower harmonics to
the higher range.
013: Talking Mod
(Talking Modulator)
This effect adds an unusual character, like a human voice, to
the input signal. Modulating the tone via dynamic modula-
tion, you can create an interesting effect that sounds as if the
guitar or synthesizer is talking.
c: Voice Top, d: Voice Center, e: Voice Bottom
These parameters assign vowels to the top, center, and
bottom position of the controller.
E.g.: When “Voice Top”=A, “Voice Center”=I, and “Voice
Bottom”=U:
If “Sweep Mode ”is set to D-mod and Ribbon is selected as
the modulation source, moving your finger from the right
to left of the ribbon controller will change the sound from
“a” to “i,” then “u.”
a
OSC Mode Note (Key Follow), Fixed
Determines whether the oscillator frequency follows the note number or
whether it is fixed
☞
b
Note Interval –48...0
Sets the pitch difference from the note number when OSC Mode=Note (Key
Follow)
☞
Note Fine
Fine adjustment of the oscillator frequency
–100...+100
☞
c
Fixed Frequency [Hz] 10.0...80.0Hz
Sets the oscillator frequency when OSC Mode=Fixed
Src Off...Tempo
Selects the modulation source for the oscillator frequency when OSC
Mode=Fixed
Amt –80...+80Hz
Sets the oscillator frequency modulation amount when OSC Mode=Fixed
d
Envelope Pre LPF 1...100
Sets the upper limit of the frequency range for which very low harmonics are
added
☞
e
Envelope Sens (Envelope Sensitivity) 0...100
Sets the sensitivity with which very low harmonics are added
Envelope Shape
Sets the oscillator’s volume envelope curve
–100...+100
f
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
Wet / Dry
Note No.
OSC Mode
Fixed
Note (Key Follow)
Sine Oscillator
Fixed Frequency
Pitch
Note Interval, Fine
Stereo In - Stereo Out
Left
Right
Wet / Dry
Envelope Sens
Envelope Shape
Envelope Shape
D
-mod
Pre LPF
Envelope Sens
Pre LPF
a
Sweep Mode D-mod, LFO
Switches between modulation source control and LFO control
b
Manual Voice Control Bottom, 1...49, Center, 51...99, Top
Voice pattern control
Src Off...Tempo
Selects the modulation source that controls the voice pattern
c
Voice Top
Selects a vowel sound at the top end of control
A, I, U, E, O
☞
d
Voice Center
Selects a vowel sound in the center of control
A, I, U, E, O
☞
e
Voice Bottom A, I, U, E, O
Selects a vowel sound at the bottom end of control
☞
f
LFO Frequency [Hz] 0.02...20.00Hz
Sets the LFO speed
☞ Fx:009,
Src
Selects the modulation source of LFO speed
Off...Tempo
Amt –20.00...+20.00Hz
Sets the modulation amount of LFO speed
g
BPM/MIDI Sync Off, On
Switches between using the frequency of the LFO speed and using the
tempo and notes
☞ Fx:009,
BPM
Selects MIDI Clock and assigns tempo
MIDI, 40...240
☞ Fx:009
Base Note
Selects the type of notes that specify the LFO speed ☞ Fx:009
Times x1...x16
Sets the number of notes that specify the LFO speed
☞ Fx:009
h
Formant Shift –100...+100
Sets the frequency to which the effect is applied
☞
Resonance
Sets the Level of resonance of the voice pattern
0...100
☞
i
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
Wet / Dry
Wet / Dry
+
D
-mod
Voice Top: A
Voice Center: I
Voice Bottom: U
A
-
I
-
U
-
E
-
O
Talking Modulator
LFO
D-mod
LFO
Sweep Mode