Filter
Top Products
MEASURE INSERT
Insert specified measures at a specified point.
• The length of the performance accordingly in-
creases by the number of inserted measures.
1. Specify the measures you wish to copy from
the source track.
• On the FROM side, specify the settings with
the corresponding buttons.
TRACK:
Specify the track number you wish to copy
the measures from.
• This function does not work for the CHORD
or RHYTHM track in which the repeat func-
tion has been stored.
• If ALL is selected, the measures are in-
serted in all tracks at the same time.
FIRST MEASURE:
Specify the first measure to copy.
LAST MEASURE:
Specify the last measure to copy.
2. Specify where you wish to insert the selected
measures.
• On the TO side, specify the settings with the
corresponding buttons.
TRACK:
Specify the track number.
• Measures from the CHORD, RHYTHM or
CONTROL track can only be inserted in the
same track.
START MEASURE:
Specify the start point to insert the selected
measures.
REPEAT:
Specify the number of times the selected
measures are to be repeated.
3. Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
• Note that if the END command is included in
the source data, it is also inserted. Any data
following the END command is not inserted.
APC TO SMF CONVERT
This function converts data to Standard MIDI File
(SMF) format, allowing you to play back song
data created using this instrument’s automatic
accompaniment and/or PERFORMANCE PADS
on an external sequencer or sound generator.
1. Use the TR ▲ and ▼ buttons to select the
track you wish to convert.
• In the PART column, the part name currently
assigned is shown.
• In the DATA column, a check mark (√) indi-
cates a track in which data is stored.
• Tracks in which RHYTHM, CONTROL, APC
and CHORD parts are stored cannot be
selected (– – – is shown).
2. Use the APC/PAD ∧ and ∨ buttons to select
the parts you wish to convert.
• Parts that are set to OFF will not be converted.
3. Press the CONVERT button.
• Note that after the conversion, the
APC/CHORD part data is cleared; if neces-
sary, save this data beforehand.
• A confirmation display appears. Press EX-
ECUTE to continue with the conversion, or
press the CANCEL button is you wish to dis-
continue.
• After the EXECUTE button is pressed, the
conversion begins. Conversion takes the
same length of time as playback.
• If you wish to discontinue the conversion
process midway, press the ABORT button.
• Because the DSP settings for the automatic
accompaniment are not converted, the nuance
of sounds in the automatic accompaniment
following conversion may sound different.
Sequencer
Part IV Sequencer
104
QQTG0671