Filter
Top Products
CYCLE RECORD
This mode allows you to have specified recording
measures continuously repeated. Thus you can
record measures by adding notes during any
cycle.
1. On the REALTIME RECORD display, specify
“REC” for a track number you are going to
record, and “PLAY” for track numbers you wish
to have played back.
2. Press the CYCLE: OFF button.
• The display looks similar to the following.
3. Use the START MEASURE ∧ and ∨ buttons
to specify the beginning measure number.
4. Use the END MEASURE ∧ and ∨ buttons to
specify the ending measure number.
• The measure in which the END command has
been stored can also be specified.
5. Press the START/STOP button.
• If the metronome is on, cycle recording of the
specified measures begins after a two-
measure count.
6. Play the keyboard.
• The specified measures are repeated, during
which time you can record by adding notes
little by little at the correct timing (over-dub-
bing).
• If you wish to erase all the performance data
from the specified measures, press the
CLEAR button.
• If the CYCLE: ON button is pressed, it changes
to OFF. This button does not function during
recording.
• To return to the REALTIME RECORD display,
press the EXIT button.
• Cycle record can also be started from the
REALTIME RECORD display whenever the
CYCLE: ON indication is shown.
7. When you have finished recording, press the
REC STOP button on the display, or turn off
the PROGRAM MENUS button.
START
CYCLE END MEASURE: 4
1234
END
Sequencer
Part IV Sequencer
82
QQTG0671