Filter
Top Products
SOUND DSP
The SOUND DSP works like a studio effects pro-
cessor, providing effects such as CHORUS,
PHASER, DELAY and DISTORTION.
• There are five SOUND DSP groups, consisting
of three for RIGHT 1, RIGHT 2 and LEFT, and
two for the automatic accompaniment or
SEQUENCER.
1. In the CONDUCTOR or PART SELECT sec-
tion, turn on the part to which this effect will
be applied.
2. Press the SOUND DSP button to turn it on.
• You can turn on the VARIATION button to
change the nuance of the effect.
• For the RIGHT 1, RIGHT 2 and LEFT parts,
when the DIGITAL DRAWBAR is on, this but-
ton is used to specify the tremolo effect type
(ROTARY SPEAKER/ROCK ROTARY).
Type and parameter settings
1. Press and hold the SOUND DSP button for a
few seconds.
• The display changes to the following.
2. Use the PART ∧ and ∨ buttons to select the
SOUND DSP you wish to set.
• Only parts that can use the SOUND DSP can
be selected.
3. Use the ∧ and ∨ buttons to select an effect
group.
• The EFFECT MEMORY is for edited effects
(see below).
4. Use the buttons to the left and right of the
display to select the type.
• If the types comprise more than one display
“page,” use the PAGE buttons to switch pages.
5. Use the DEPTH ∧ and ∨ buttons to set the
depth of the effect.
• The depth does not change for some types.
• This display can also be accessed from the
REVERB & EFFECT MENU display. (Refer to
page 162.)
EFFECT EDIT
The effects can be edited and then stored in a
memory.
• MEMORY LIST is used to store all SOUND
DSP groups.
1. Select an effect type to use as a base.
2. Press the EDIT button.
• The display changes to the following.
3. Use the PARAMETER ▲ and ▼ buttons to
select the parameter.
• Parameters with a (V) mark are effective when
the VARIATION button is turned on.
4. Use the VALUE ∧ and ∨ buttons to adjust the
setting.
5. Press the NAMING button and assign a name
to the effect, if necessary.
• Refer to page 66 for details about the
NAMING procedure.
6. Use the EFFECT MEMORY ▲ and ▼ buttons
to specify the location in which to store the
edited effect.
7. Press the WRITE button.
• The parameters vary depending on the effect
type selected as the base.
SOUND
DSP
VARIATION
Sounds and effects
Part I Sounds and effects
43
QQTG0671