Filter
Top Products
Panel Write
You can change the panel status which is in effect at the beginning of the song. These are the settings
which are recalled when the SEQUENCER RESET button is pressed.
1. On the SEQ MENU display, use the SONG ∧
and ∨ buttons to select the song number. Then
select PANEL WRITE.
• The display looks similar to the following.
2. Use the panel buttons to change to the desired
panel settings.
3. Press the OK button.
• “COMPLETED!” is shown on the display.
• PANEL WRITE is automatically activated at
the when you start to record.
• For rhythm data, the data in the RHYTHM part
has priority.
Song Select
You can select a desired song from the list of recorded songs.
1. On the SEQ MENU display, select RECORD
& EDIT.
2. On the RECORD & EDIT display, select SONG
SELECT.
• The display looks similar to the following.
3. Use the SONG SELECT ▲ and ▼ buttons to
select a song.
• The total amount of memory used for the cur-
rent song is shown as a percentage (%) to the
right of the song name.
• If the NAMING button is pressed, the NAMING
display appears.
• To optimize memory, songs you do not wish
to preserve should be deleted. (Refer to page
97.)
Sequencer
Part IV Sequencer
86
QQTG0671