Filter
Top Products
Common Setting
Set the functions which are common to all parts.
1. On the MIDI MENU display, select COMMON
SETTING.
• The display looks similar to the following.
2. Use ▲ and ▼ buttons to select the item.
NOTE ONLY:
Of the performance data, specify whether or
not only note data is exchanged.
PROGRAM CHANGE TO P. MEM:
Enable or disable the exchange of program
change numbers for the RIGHT 1 part by
operation of the PANEL MEMORY buttons.
• For this setting, the PANEL MEMORY 1 to 8
program change numbers correspond to the
bank numbers as follows:
BANK A = 0 to 7
BANK B = 8 to 15 ...
INTRO, FILL-IN, ENDING:
Enable or disable the exchange of intro, fill-in
and ending data.
APC CONTROL:
Enable the exchange of data for the on/off sta-
tus of the AUTO PLAY CHORD’s ONE FIN-
GER, FINGERED and PIANIST modes.
FADE IN/OUT:
Specify whether or not FADE IN/OUT data is
exchanged.
PROGRAM CHANGE MODE
NX SOUND:
Program change numbers are standardized
among NX SOUND Technics models which
are set to this mode. The program change
number assigned to a given sound on one
model is assigned to the same sound on all
models which are set to the same mode.
PREVIOUS TECH:
Program change numbers are standardized
among non-NX SOUND Technics models
which are set to this mode. The program
change number assigned to a given sound
on one model is assigned to the same sound
on all models which are set to the same
mode.
MAP R:
GS basic sounds are transmitted and re-
ceived as GS program change numbers.
MAP Y:
XG basic sounds are transmitted and re-
ceived as XG program change numbers.
*GS is a trademark of Roland Corporation. XG is a trade-
mark of Yamaha Corporation.
DRUMS TYPE
NX SOUND:
Keyboard percussion instrument sounds
correspond to the same key note numbers
for connected NX SOUND Technics models
that are set to this type.
PREVIOUS TECH:
Keyboard percussion instrument sounds
correspond to the same key note numbers
for connected non-NX SOUND Technics
models that are set to this type.
SONG SELECT
ON:
Song number data can be exchanged.
OFF:
Song number data cannot be exchanged.
PREVIOUS MODEL MODE
ON:
INTRO, FILL IN, ENDING and APC CON-
TROL, FADE IN/OFF data are converted to
CONTROL CHANGE data for previous
models* and then transmitted.
OFF:
The above settings are not converted.
* “Previous models” include all Technics instrument
models except for:
KN7000/6500/6000
PR604/804/603/703/903/1000
3. Use ∧ and ∨ buttons to change the setting.
4. Repeat steps 2 and 3 for the other settings as
desired.
MIDI
Part XIII MIDI
192
QQTG0671