Filter
Top Products
Correcting the data
1. In the STEP RECORD mode, specify the track
you wish to correct.
2. Use the MEAS buttons to go to the measure
you wish to modify. Use the CURSOR buttons
to move the cursor to the point (
*
) you wish
to edit.
• The data stored at that point is shown on the
display.
• When multiple data is stored at one point,
different data is displayed in order each time
a CURSOR button is pressed. When a chord
is recorded, a different note in the chord is
displayed each time a CURSOR button is
pressed.
3. Correct the data.
There are three types of data:
Performance data
NOTE data (note pitch) and VEL data (how hard
the key was played) and LEN data (1 = 1/96 of
a quarter note [ ]) are displayed. Use the rele-
vant buttons to correct the data as desired.
Sound data
The name of the sound is displayed. Change the
sound as desired (the sound setting display is
interposed on the current display).
Control data
The name of the function is displayed. Change
the data as desired.
• Press the ERS button to erase the data which
is displayed.
• You can also correct data which was stored
in the REALTIME RECORD mode.
• Performance (NOTE) data can be recorded or
edited on a piano roll display, and there is also
a specialized display for recording and editing
the DRUMS part data. (Refer to page 99.)
Assigning the images
Assign images to the selected point (PIC) of a
song.
1. Use the SONG SELECT ∧ and ∨ of the
SEQUENCER MENU display to select a song
number to which the images will be assigned,
and select RECORD & EDIT.
2. Select STEP RECORD on the RECORD &
EDIT display.
3. Use the balance buttons below the display to
select CONTROL TRACK (CTL).
• The display looks similar to the following.
4. Use the MEAS ∧ and ∨ buttons to specify the
measure to assign.
5. Use the CURSOR buttons to move the cursor
(reversed box) to the point you are going to
assign an image.
• Each point represents one-eighth of a quarter
note (a thirty-second note).
6. Press the PIC button.
• The display looks similar to the following.
7. Use the PRESET/USER button to select one.
PRESET:
preset images
USER:
your original images loaded beforehand
(Refer to page 91.)
8. Use the VALUE button to select the image
number.
9. Press the YES button.
• The image of the specified number is assigned
to that point (PIC).
10.Repeat the steps 4 to 9 to continue assigning.
Sequencer
Part IV Sequencer
90
QQTG0671