Filter
Top Products
4. Use the COUNT IN MEASURE ∧ and ∨ but-
tons to specify the number of lead-in measures
you wish to have played back before the
punch-in measure.
• Set the metronome to on or off with the ON
or OFF button.
5. Press the EXIT button.
• The display changes to the PUNCH RECORD
display.
6. Press the START/STOP button.
• Playback begins from the measure indicated
by CURRENT MEASURE on the display.
• Pertinent information, such as the FIRST
MEASURE, is shown in the upper section of
the display.
7. Correct the performance.
• The mode changes automatically to the re-
cording mode at the specified FIRST measure.
Begin playing at this point. The mode auto-
matically changes back to the playback mode
at the specified LAST measure.
• To discontinue punch recording in the middle,
press the CANCEL button. In this case, the
recorded contents up to that point are erased.
Step Record
STEP RECORD is simply a method of making a tune by storing the sounds note-by-note on the display.
Instead of playing the keyboard directly as in the REALTIME RECORD mode, you can take your time
to input each single note. This is an especially effective method for storing complicated passages that
are difficult to play or when the exact timing of a part is critical.
Recording procedure
Record the keyboard performance and panel
changes.
1. On the SEQ MENU display, use the SONG
SELECT ∧ and ∨ buttons to select the song
number. Then select RECORD & EDIT.
2. On the RECORD & EDIT display, select STEP
RECORD.
• The display changes to the PART SELECT
display.
3. Use the balance buttons below the display to
specify the track for the part you are going to
record (only one track can be selected at a
time).
• The display changes to the STEP RECORD
input display similar to the following.
• If you selected the track to which the CHORD
part has been assigned, the display changes
to the STEP RECORD: CHORD display.
(Refer to page 92.)
• If you selected the track to which the RHYTHM
part has been assigned, the display changes
to the STEP RECORD: RHYTHM display.
(Refer to page 94.)
• If you selected the track to which the CON-
TROL part has been assigned, the display
changes to the STEP RECORD: CONTROL
display.
Sequencer
Part IV Sequencer
88
QQTG0671