Filter
Top Products
EQUALIZER HIGH:
Sound quality correction in the high range.
Select EQUALIZER HI FC; use the buttons
below the display to set the standard
frequency. Select EQUALIZER HI GAIN; use
the buttons below the display to set the ratio
of change.
EQUALIZER LOW:
Sound quality correction in the low range.
Select EQUALIZER LOW FC; use the buttons
below the display to set the standard
frequency. Select EQUALIZER LOW GAIN;
use the buttons below the display to set the
ratio of change.
KEY SHIFT:
Select KEY SHIFT. Use the buttons below the
display to adjust the shift width of the output
pitch of each part (in semitone increments; – 24
to +24).
MIDI CHANNEL:
Select MIDI CHANNEL. Use the balance but-
tons below the display to set the MIDI channel
for each part (CH1– CH16).
• Information about MIDI channels can be found
on page 190.
LOCAL CONTROL:
Select LOCAL CONTROL. Use the balance
buttons below the display to turn LOCAL CON-
TROL ON or OFF for each part.
• Even at the same numerical value, the PAN
and effects may differ depending on the sound.
• For some parts, such as the automatic accom-
paniment parts, the items that can be adjusted
are limited.
EDIT MIXER
If you press the EDIT MIXER button on the PAGE
5/5 display, the display changes the setting dis-
play to modify the sounds.
<PAGE 1>
VIBRATO RATE:
Select VIBRATO RATE. Use the buttons
below the display to adjust the vibrato speed
for each part (0 to 127).
VIBRATO DEPTH:
Select VIBRATO DEPTH. Use the buttons
below the display to adjust the vibrato depth
for each part (0 to 127).
VIBRATO DELAY:
Select VIBRATO DELAY. Use the buttons
below the display to specify the time interval
from when the keys are played until the vibrato
starts for each part(0 to 127).
FILTER RESONANCE:
Select FILTER RESONANCE. Use the buttons
below the display to set the amount of reso-
nance applied to each part (0 to 127).
<PAGE 2>
BRIGHTNESS:
Select BRIGHTNESS. Use the buttons below
the display to set the amount of brightness ap-
plied to each part (0 to 127).
ATTACK TIME:
Select ATTACK TIME. Use the buttons below
the display to set the sound attack time for
each part (0 to 127).
DECAY TIME:
Select DECAY TIME. Use the buttons below
the display to set the sound decay time for
each part (0 to 127).
RELEASE TIME: Select RELEASE TIME. Use
the buttons below the display to set the release
time for each part (0 to 127).
Sound
Part VIII Sound
158
QQTG0671