Filter
Top Products
DRUM PATTERN OUTPUT
ON: Data from the DRUMS part is transmitted.
OFF: Data from the DRUMS part is not trans-
mitted.
AUTO PLAY CHORD OUTPUT
ON: The data for the ACCOMP, BASS and
CHORD parts is transmitted.
OFF: The data for the above parts is not trans-
mitted.
• MIDI channels should be assigned to the
above parts before exchanging data.
AUTO OCTAVE SHIFT OUTPUT
ON: If the octave has been automatically
changed, the data of the transposed notes
is transmitted, depending on the sound.
OFF: The note data of the played keys is trans-
mitted.
3. Use the ∧ and ∨ buttons to select the setting.
4. Repeat steps 2 and 3 for each item as desired.
MIDI Presets
Establish the optimum settings depending on how this Keyboard is connected to other equipment, and
on whether this Keyboard is used as the master or the slave.
1. On the MIDI MENU display, select MIDI PRE-
SETS.
• The display looks similar to the following.
2. Use the ▲ and ▼ buttons to select the con-
nection setup.
• The PAGE 1/4 display shows connection
setups with this instrument as the SLAVE. And
the PAGE 2/4 display shows connection
setups with this instrument as the MASTER.
• The MASTER is the instrument used to trans-
mit data, and the SLAVE is the instrument
used to receive the data.
• Use the buttons below the display to select
WITHOUT APC (the AUTO PLAY CHORD is
not used) or WITH APC (the performance in-
cludes AUTO PLAY CHORD).
3. Press the OK button.
• When the settings have been successfully
stored, “COMPLETED!” appears on the dis-
play.
Notice
When an instrument such as an organ or ac-
cordion with separate or divided keyboards
dedicated to melody and chords is used as the
master instrument, if this instrument’s split
point is set to a note below the lowest note of
the melody keyboard of the master instrument,
it is possible to produce melody notes on mul-
tiple parts by this instrument’s CONDUCTOR
settings.
• Assign the RIGHT 1 channel as the CHAN-
NEL for the melody keyboard. Assign the
CHORD channel (or if you also wish the
played note to be produced, CHORD +
LEFT) as the CHANNEL for the chord key-
board.
• You will also have to specify CONDUCTOR
as the RIGHT 1 INPUT for the INPUT/OUT-
PUT SETTING.
MIDI
Part XIII MIDI
194
QQTG0671