Filter
Top Products
104
Creating a Patch
Key Fade Upper (Keyboard Fade Width Upper)
This determines what will happen to the tone’s level when a
note that’s higher than the tone’s specified keyboard range is
played. Higher settings produce a more gradual change in
volume. If you don’t want the tone to sound at all when a
note below the keyboard range is played, set this parameter
to “0.”
Value:
0–127
fig.06-027.e
TMT Velocity Control
(TMT Velocity Control Switch)
TMT Velocity Control determines whether a different tone is
played (ON) or not (OFF) depending on the force with which
the key is played (velocity).
When set to “RANDOM,” the patch’s constituent tones will
sound randomly, regardless of any Velocity messages.
When set to “CYCLE,” the patch’s constituent tones will
sound consecutively, regardless of any Velocity messages.
Value:
OFF, ON, RANDOM, CYCLE
Instead of using Velocity, you can also have tones
substituted using the Matrix Control (p. 105). However,
the keyboard velocity and the Matrix Control cannot be
used simultaneously to make different tones to sound.
When using the Matrix Control to switch tones, set the
Velocity Control parameter to “OFF.”
Velo Fade Lower (Velocity Fade Width Lower)
This determines what will happen to the tone’s level when
the tone is played at a velocity lower than its specified
velocity range. Higher settings produce a more gradual
change in volume. If you want notes played outside the
specified key velocity range to not be sounded at all, set this
to “0.”
Value:
0–127
Velo Range Lower (Velocity Range Lower)
This sets the lowest velocity at which the tone will sound.
Make these settings when you want different tones to sound
in response to notes played at different strengths.
Value:
1–UPPER
Velo Range Upper (Velocity Range Upper)
This sets the highest velocity at which the tone will sound.
Make these settings when you want different tones to sound
in response to notes played at different strengths.
Value:
LOWER–127
If you attempt to set the Lower velocity limit above the
Upper, or the Upper below the Lower, the other value
will automatically be adjusted to the same setting.
When using the Matrix Control to have different tones
played, set the lowest value (Lower) and highest value
(Upper) of the value of the MIDI message used.
Velo Fade Upper (Velocity Fade Width Upper)
This determines what will happen to the tone’s level when
the tone is played at a velocity greater than its specified
velocity range. Higher settings produce a more gradual
change in volume. If you want notes played outside the
specified key velocity range to not be sounded at all, set this
to “0.”
Value:
0–127
fig.06-028.e
Range Lower
Range Upper
Fade Lower
Fade Upper
Level
Pitch
Range Lower
Range Upper
Fade Lower
Fade Upper
Level
Velocity
VS-700_r_e.book 104 ページ ２００８年１１月２０日 木曜日 午後２時２８分