Filter
Top Products
118
Creating a Patch
Delay Time (LFO1/LFO2 Delay Time)
Delay Time (LFO Delay Time) specifies the time elapsed
before the LFO effect is applied (the effect continues) after
the key is pressed (or released).
Value:
0–127
After referring to
How to Apply the LFO
(p. 119),
change the setting until the desired effect is achieved.
When using violin, wind, or certain other instrument
sounds in a performance, rather than having vibrato
added immediately after the sounds are played, it can
be effective to add the vibrato after the note is drawn
out somewhat. If you set the Delay Time in conjunction
with the Pitch Depth parameter and Rate parameter, the
vibrato will be applied automatically following a certain
interval after the key is pressed. This effect is called
Delay Vibrato
.
Delay Time KF
(LFO1/LFO2 Delay Time Keyfollow)
Adjusts the value for the Delay Time parameter depending
on the key position, relative to the C4 key (center C). To
decrease the time that elapses before the LFO effect is
applied (the effect is continuous) with each higher key that is
pressed in the upper registers, select a positive value; to
increase the elapsed time, select a negative value. Larger
settings will produce greater change. If you do not want the
elapsed time before the LFO effect is applied (the effect is
continuous) to change according to the key pressed, set this
to “0.”
Value:
-100, -90, -80, -70, -60, -50, -40, -30, -20, -10, 0,
+10, +20, +30, +40, +50, +60, +70, +80, +90, +100
fig.06-031.e
Fade Mode (LFO1/LFO2 Fade Mode)
Specifies how the LFO will be applied.
Value:
ON-IN, ON-OUT, OFF-IN, OFF-OUT
After referring to
How to Apply the LFO
(p. 119),
change the setting until the desired effect is achieved.
Fade Time (LFO1/LFO2 Fade Time)
Specifies the time over which the LFO amplitude will reach
the maximum (minimum).
Value:
0–127
After referring to
How to Apply the LFO
(p. 119),
change the setting until the desired effect is achieved.
Key Trigger (LFO1/LFO2 Key Trigger)
This specifies whether the LFO cycle will be synchronized to
begin when the key is pressed (ON) or not (OFF).
Value:
OFF, ON
Pitch Depth (LFO1/LFO2 Pitch Depth)
★
Specifies how deeply the LFO will affect pitch.
Value:
-63– +63
TVF Depth (LFO1/LFO2 TVF Depth)
★
Specifies how deeply the LFO will affect the cutoff frequency.
Value:
-63– +63
TVA Depth (LFO1/LFO2 TVA Depth)
★
Specifies how deeply the LFO will affect the volume.
Value:
-63– +63
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
Key
Time
VS-700_r_e.book 118 ページ ２００８年１１月２０日 木曜日 午後２時２８分