Filter
Top Products
156
Installing the ARX Expansion Board
Install the Expansion Board after removing the panel cover.
1.
Before installing the Expansion Board, turn off the power of the VS-700R and all connected
devices, and disconnect all cables, including the Power cable, from the VS-700R.
2.
From the VS-700R, remove only the screws shown in the following diagram, and detach the cover.
VS-700R Top Panel
fig.exp02.eps
3.
Orient the board with the slot of the VS-700R as shown in the illustration.
fig.attach01.eps
How to Install an Expansion Board
Slot of the VS-700R
Board
(expansion board)
Non-latched holders
Latched holders
Roland logo
Holes that engage the
non-latched holders
VS-700_r_e.book 156 ページ ２００８年１１月２０日 木曜日 午後２時２８分