Filter
Top Products
79
Connecting Recording Equipment
Overview Connections VS-700C Console VS-700R I/O Fantom VS Appendix
fig.VS-700-rec02-digi-e.eps
When connection cables with resistors are used, the volume level of equipment connected to the inputs
(INPUT 1–8 jacks, AUX IN Jack) may be low. If this happens, use connection cables that do not contain resistors.
Connections to the Digital Connectors
VS-700R Rear Panel
Connecting a Digital Audio Source
If you want to digitally connect a DAT or similar device, connect its output connector (e.g., DIGITAL OUT connector) to the VS-700R's DIGITAL IN
connector.
If you're connecting an ADAT device,
connect it to the ADAT connector.
A maximum of eight channels can be input
Using an
AES/EBU
connector
Using
a coaxial
connector
The DIGITAL 1 coaxial connector and AES/EBU connector
are a mutually exclusive selection. To make your choice, go
to SONAR’s “Tools” menu, open “ VS-700,” select the “MIC
PRE” tab, and make the desired setting in the “DIGITAL 1
INPUT” field.
VS-700_r_e.book 79 ページ ２００８年１１月２０日 木曜日 午後２時２８分