Filter
Top Products
163
Overview Connections VS-700C Console VS-700R I/O Fantom VS Appendix
Attaching the Rackmount Brackets
If you want to install the VS-700R I/O in a 19” rack, attach the included rackmount brackets.
1.
Disconnect all connection cables from the VS-700R, including the power cord.
2.
As shown in the illustration below, remove three screws each from the left and right sides of the
VS-700R.
fig.rack01.eps
3.
Attach the rackmount brackets using the screws you removed in step 2.
fig.rack02.eps
4.
Install the unit in the rack as appropriate for your situation.
* Fasten the screws securely.
* Be careful not to lose the included screws.
* For safety’s sake, do not use any screws other than the included ones.
* If you install the system in a 19" rack, you must leave at least 1 cm of space outside the intake vent and exhaust vent.
* Be careful when installing the unit in the rack so you do not get your fingers pinched.
* For the installation, refer also to
“Placement”
(p. 6).
VS-700_r_e.book 163 ページ ２００８年１１月２０日 木曜日 午後２時２８分