Filter
Top Products
73
RECORD/EDIT Section
Overview Connections VS-700C Console VS-700R I/O Fantom VS Appendix
To Specify the Loop Region
1.
Select transport mode (p. 58).
2.
Hold down the [SHIFT] button and press the [LOOP] button. The [LOOP] and [
] buttons will
blink.
3.
Use the jog/shuttle and cursor to move to the loop-start point.
4.
Press the [
] button. The [LOOP] and [ ] buttons will blink.
5.
Use the jog/shuttle and cursor to move to the loop-end point.
6.
Press the [LOOP] button.
To Insert a Marker
1.
Use the jog/shuttle and cursor to move to the time at which you want to insert a marker.
2.
Press the [MARKER] button.
3.
The marker dialog box will appear.
4.
As desired, edit the name, the time, and the groove clip pitch.
5.
Press the [OK/ENTER] button.
To Access the Marker View
1.
Hold down the [COMMAND] button and press the [MARKER] button.
2.
The marker view will appear.
To View Marker Information in the Console
1.
Hold down the [SHIFT] button and press the [MARKER] button.
2.
Marker information will appear in the console.
VS-700_r_e.book 73 ページ ２００８年１１月２０日 木曜日 午後２時２８分