Filter
Top Products
152
System Settings
System Control
Parameter
Value Description
Source 1–4
OFF,
CC01–31, 33–95,
PITCH BEND
AFTERTOUCH
System Control Assign selects the MIDI message used as the System Control.
OFF:
The system control knob will not be used.
CC01–31, 33–95:
Controller numbers 1–31, 33–95
PITCH BEND:
Pitch Bend
AFTERTOUCH:
Aftertouch
System Control
This function, which departs from previously used methods, and instead allows you to use MIDI messages to change tone settings
in realtime, is called the Matrix Control (p. 121). Similarly, the function allowing you to use MIDI messages to change multi-effects
settings in realtime is called the Multi-effects Control (p. 149).
Normally, the Matrix Control is used for making patch settings, and the Multi-effects Control for making settings to patches,
rhythm sets, and performances. However, if you do not need to change the MIDI messages used for matrix control or multi-effects
control by each patch/rhythm set/performance, or if you want to use a specific MIDI message for matrix control or multi-effects
control, you will want to make use of System Control. In other words, you could call the System Controls global Matrix Control/
Multi-effects Control for the entire Fantom VS.
You can use up to four System Controls.
VS-700_r_e.book 152 ページ ２００８年１１月２０日 木曜日 午後２時２８分