Filter
Top Products
126
Creating a Rhythm Set
Tone Pitch Bend Range
(Rhythm Tone Pitch Bend Range)
Specifies the amount of pitch change in semitones (4
octaves) that will occur when the Pitch Bend Lever is moved.
The amount of change when the lever is tilted is set to the
same value for both left and right sides.
Value:
0–48
Tone Receive Expression
(Rhythm Tone Receive Expression Switch)
For each rhythm tone, specify whether MIDI Expression
messages will be received (ON), or not (OFF).
Value:
OFF, ON
Tone Receive Hold-1
(Rhythm Tone Receive Hold-1 Switch)
For each rhythm tone, specify whether MIDI Hold-1 messages
will be received (ON), or not (OFF).
Value:
OFF, ON
If “NO SUS” is selected for Env Mode parameter (p. 125),
this setting will have no effect.
Tone Receive Pan Mode
(Rhythm Tone Receive Pan Mode)
For each rhythm tone, specify how pan messages will be
received.
Value
CONTINUOUS:
Whenever Pan messages are received, the
stereo position of the tone will be changed.
KEY-ON:
The pan of the tone will be changed only
when the next note is played. If a pan
message is received while a note is sounding,
the panning will not change until the next
key is pressed.
The channels cannot be set so as not to receive Pan
messages.
One Shot Mode
The sound will play back until the end of the waveform (or
the end of the envelope, whichever comes first). The result
will be the same as when the envelope’s Tone Env Mode
parameter (p. 125) is set to NO-SUS.
Value:
OFF, ON
Relative Level
Corrects for the volume of the rhythm tone.
This parameter is set by the key-based controller system
exclusive message. Normally, you should leave it set to 0.
Value:
-64-+63
If the rhythm tone level is set to 127, the volume will not
increase beyond that point.
VS-700_r_e.book 126 ページ ２００８年１１月２０日 木曜日 午後２時２８分