Filter
Top Products
148
Adding Effects
Reverb Output
Reverb Output Level
Adjusts the volume of the sound that has passed through
reverb.
Value:
0–127
If you want to use common controllers for the entire
Fantom VS, select “SYS CTRL 1”–”SYS CTRL 4.” MIDI
messages used as System Control 1–4 are set with the
Sys Ctrl 1–4 Source parameters (p. 152).
In patch/rhythm set mode, there are parameters that
determine, for each tone/rhythm tone, whether or not
Pitch Bend, Controller Number 11 (Expression) and
Controller Number 64 (Hold 1) are received (p. 120).
When these settings are “ON,” and the MIDI messages
are received, then when any change is made in the
settings of the desired parameter, the Pitch Bend,
Expression, and Hold1 settings also change
simultaneously. If you want to change the targeted
parameters only, then set these to “OFF.”
• There are parameters that determine whether or not
specific MIDI messages are received for each MIDI
channel (p. 120). When using the multi-effects control,
confirm that any MIDI messages used for the multi-
effects control will be received. If the Fantom VS is set
up such that reception of MIDI messages is disabled,
then the multi-effects control will not function.
Control 1–4 Dest
(Multi-Effects Control 1–4 Destination)
Sets the multi-effects parameters to be controlled with the
multi-effects control. The multi-effects parameters available
for control will depend on the multi-effects type.
Control 1–4 Sens
(Multi-Effects Control 1–4 Sensitivity)
Sets the amount of the multi-effects control’s effect that is
applied. To make an increase in the currently selected value
(to get higher values, move to the right, increase rates, and so
on), select a positive value; to make a decrease in the
currently selected value (to get lower values, move to the left,
decrease rates, and so on), select a negative value. For either
positive or negative settings, greater absolute values will
allow greater amounts of change. Set this to “0” if you don’t
want to apply the effect.
Value:
-63– +63
MFX Control Channel
(Multi-Effects Control Channel)
This determines the channel that will be used for reception
when using the Multi-effects Control to modify multi-effects
parameters in real time, when the MFX1–3 Source parameter
(p. 149) is set to “PRF.” Set this to “OFF” when the Multi-
effects Control is not being used.
Value:
1–16, OFF
14
VS-700_r_e.book 148 ページ ２００８年１１月２０日 木曜日 午後２時２８分