166
Connecting Two VS-700R I/O Units
The Advantages of Connecting VS-700R I/O Units
By connecting two VS-700R I/O units, you'll be able to take advantage of the audio input/output of the two units,
have access to two synthesizers (Fantom VS), and be able to use two ARX expansion boards.
You will need a faster system if you connect two VS-700R I/O units.
Changes to the Settings
If you use a second I/O unit, open the top cover (ARX slot) of the second unit and set its SETTING DIP switches as
follows. Then turn the VS-700R’s power off, then on again.
fig.dsw2.eps
The audio/MIDI device names for the second I/O unit will be the same as for the first unit but with a “2”
added to the port name.
Connections
1.
Set the Sampling Rate of the two VS-700R I/O units to the same value (p. 80).
2.
Connect the second VS-700R I/O unit to your computer’s USB connector.
Only ASIO is supported when using the audio input/output of the second unit
• Applications that do not support ASIO cannot be used
• The audio ports of the second unit cannot be selected if SONAR is set to the WDM/KS or MME driver
mode.
Normal setting Setting for the second VS-700R unit
VS-700_r_e.book 166 ページ 2008年11月20日 木曜日 午後2時28分