Filter
Top Products
125
Track editing
12
■ Specify the editing region
For most commands, you will need to set the Start (the
beginning of the edited region) and End (the end of the
edited region) parameters to specify the region that will
be affected by the command.
5
To specify the beginning of the region to be
edited, move the cursor to the desired digit
of the Start field, and turn the [DATA/JOG]
dial.
The Start/End parameters are displayed at the right
of the TR field.
You can set the Start/End parameters in terms of the
counter display format (the value at the left) or in
units of measures/beats (the value at the right).
Move the cursor to the digit that you want to
change, and turn the [DATA/JOG] dial to set the
value.
6
To specify the end of the region to be edited,
move the cursor to the desired digit of the
End field, and turn the [DATA/JOG] dial.
Tip!
Tip!
If you move the cursor to the Start or End parameter and
press the [ENTER] key, the current counter location will
be input. Alternatively, you can recall a locate point or
marker to move to that location in the song, and then
press the [ENTER] key to input that location as the value
of the Start or End parameter.
Note
Note
For some commands, you will also need to specify a loca-
tion in the editing-destination track. In the same way as
described above, move the cursor to the counter display
format field or the measure/beat field, and specify the
location.
■ Execute the command
When you have finished setting parameters, execute the
command.
7
Move the cursor to the EXEC button, and
press the [ENTER] key.
A popup window will ask you to confirm the opera-
tion.
8
Move the cursor to the OK button to execute
the command, or move the cursor to the
CANCEL button to cancel without executing.
Then press the [ENTER] key.
Tip!
Tip!
Even after you press the [ENTER] key to execute the com-
mand, you can press the [UNDO/REDO] key to return to
the state prior to executing the command. You can use
this function to compare the original data with the results
produced by executing the command.
Note
Note
If as a result of executing a command, a track no longer
contains any recorded data, the name of that track will
change to “-NO REC-”.
Start parameter
(beginning of the region to be edited)
End parameter
(end of the region to be edited)